Today I am sharing how to reupholster a couch. Last year I shared the most insane project I have ever done, a DIY couch. I sawzalled an existing couch in half and removed two feet and then assembled it back together finishing it off with new upholstery. A couple weekends ago, I decided to reupholster it again with an old Pottery Barn slip cover that was in the bottom of my closet.
The before upholstery looked like this:
Kind of crazy right? Well this little o’l couch is getting a new look, again.
Do you love the look of slip covers but hate all the wrinkles and mess? The one piece slip covers that you buy as is are beautiful as long as you don’t sit on the furniture.
Do you know what I am talking about?
They come in one size and usually, you have excessive amounts of fabric tucked everywhere. Drives me crazy! So my solution was to re-use the existing large one piece slip cover and cut it to size and staple/nail it to the couch.
First, drape your slip cover over your piece of furniture.
Next, cut the excessive fabric (on the floor) off but be sure to not cut the pleated part. You will want to save the pleated part to re-staple to the couch along the bottom edge.
Now it’s time to cut out the middle piece. I decided to cut straight across being sure to leave enough fabric to cover the back and sides of the couch.
Don’t worry, this works!
Now, simply tuck your fabric and staple with your hand powered staple gun. I used a compressor and heavy duty staple gun with 1/4″ staples. Be sure to staple to the wood part/frame of the couch.
Try to staple as close to the bottom and up underneath in order to hide the staple.
I cut a piece of fabric (from the slip cover excess) to cover the front and stapled. I chose to leave the arms of the couch “loose” simply because I wanted a casual look. You can always staple the fabric around the arms to give it a more tailored look. It just depends what look you want. The staple gun is at your disposal! If you make a mistake or don’t like it, just get a hammer and screw driver and pry out the staple. No biggie.
Don’t worry about getting it perfect. You will be able to cover the edges with the existing pleated skirt that you cut off earlier. See below how how stapled the skirt back on the couch. This gives the couch a finished look.
I tried to staple where the staples wouldn’t be seen but a couple do show. You can purchase roping or ribbon in the fabric store and use stitch witchery to adhere to the slipcover if you want to hide the staples. For me, they are hardly noticeable.
Of course if you want it perfect, you will need to invest hundreds of dollars and pay to have it professionally reupholstered. For me, that wasn’t an option. I think the couch recovered in a camel covered slip cover fits right in with our newly renovated modern cottage pool house.
For the cushion, I used the remaining fabric that I had cut off in the beginning and sewed the ends together and used velcro to close the seam. I ran out of zippers and velcro is what I had so that is what I used. I may sew a zipper on the cushion cover at some point.
The beautiful thing about this reupholstery project, I re-used a slip cover that cost over $300 and I can now sit on this couch without the fabric moving and looking messy. In my book, it was successful. A fresh new look for a couch that use to be two feet longer for zero money! This project only took me two hours and seriously, learning how to reupholster a couch is very easy. Get yourself a small compressor and heavy duty staple gun (that works with a compressor), some fabric and get busy! Be sure to check out the rest of our pool house makeover and diy planked wall in this space. If you take a peak at the before pictures of this pool house, it’s hard to believe it’s the same space. It’s come a long way!